Starter Cut-Off (Blue/Brown); Recommended Wiring - Pioneer Premier DEH-P520 Manuel D'installation

DFS Alarm Installation

STARTER CUT-OFF (Blue/brown)

The blue/brown lead will provide a continuous +12 V output while alarm is sounding and
for 30 minutes after initial trigger, up to 5 consecutive triggers. This lead has a maximum
current capability of 500 mA and can be used to trigger a relay to disable the starter.
Note:
• In order for the "DFS Alarm" to operate when a window is broken, connect this product's white/red
(ALARM SENSOR) lead to glass sensor securely.
• In order for the "DFS Alarm" to operate when a door is forced open, connect this product's
white/yellow (DOOR SWITCH) lead securely.

Recommended Wiring:

30 amp relay (sold separately) required to disable starter.
• Connect blue/brown lead to one side of relay coil.
• Connect other side of coil to ground.
• Locate starter wire under dash, near steering column.
• Cut starter wire and try to start vehicle to verify wire is correct.
• Connect key side of cut wire to normally closed pin.
• Connect starter side of cut wire to common pin.
30 A "SPDT" RELAY
(sold separately)
To Starter
13
See the
"Avoiding Trouble".
Blue/brown
White/orange (refer to "DOOR LOCK".)
White/red (refer to "ALARM SENSOR".)
From Ignition
Switch
Brown (refer to "ALARM OUTPUT".)
White/yellow (refer to "DOOR SWITCH".)
This Product
Fig. 9