Télécharger Imprimer la page

Registered Trademarks; Safety Definitions; General Safety; Safety Instructions For Operation - Husqvarna X-COM R Manuel D'utilisation

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 237
Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
Consult the dealer for help.
Marking on the product can be found if you remove the
sealing ring and foam rubber insert on the right earmuff.
Contains transmitter module IC: 12246A-
BM64S2
This device complies with Industry Canada license-
exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause
interference, and (2) this device must accept any
interference, including interference that may cause
undesired operation of the device.

Safety definitions

The definitions below give the level of severity for each
signal word.
WARNING: Injury to persons.
CAUTION: Damage to the product.
Note: This information makes the product easier to use.

General safety

WARNING: Read the warning instructions
that follow before you use the product.
Use and save these instructions.
For optimal fit and function, make sure that you have
selected the correct product for your use.
Do not change or remove parts on the product. Only
do changes that are given in this operator's manual.
The noise attenuation of the product will be severely
impaired if you do not follow the instructions in this
operator's manual. Ear-muffs, and in particular
cushions, may deteriorate with use and should be
examined at frequent intervals for cracking and
leakage, for example.
This product may be adversely affected by certain
chemical substances. Further information should be
sought from the manufacturer. Keep away from
aggressive substances and clean the product
regularly. Use a cloth with water and soap. Do not
wash or put fully into water.
579 - 005 - 05.07.2019
Under Industry Canada regulations, this radio
transmitter may only operate using an antenna of a type
and maximum (or lesser) gain approved for the
transmitter by Industry Canada. To reduce potential
radio interference to other users, the antenna type and
its gain must be so chosen that the equivalent
isotropically radiated power (e.i.r.p.) is not more than
that necessary for successful communication.
Marking on the product can be found if you remove the
sealing ring and foam rubber insert on the right earmuff.

Registered trademarks

Bluetooth
®
The
trademarks owned by
such marks by Husqvarna is under license.
Safety
All service and repair work must be done by an
approved service workshop. Only use Husqvarna
original spare parts.
Never use the ear-muffs longer than 10 years from
the manufacturing date stated on the packaging.

Safety instructions for operation

The wearer should ensure that the ear-muffs are
worn at all times in noisy environments.
Be more careful and listen for warning signals when
you use the product. The noise from warning signals
can be decreased when you use the product.
The audibility of warning signals at specific
workplace may be impaired while using the
entertainment facility.
Make sure that the product is not hit during
transportation and use.
Only use the product between temperatures -20°C
and +55°C. If you use the product in other
temperatures, this can cause damage to the
electronics, battery and mechanical parts. This
model of earmuffs has satisfied the requirements of
the drop test at −20 °C.
Make sure that you know how to use the product
before use. Speak to your servicing dealer if there is
damage on the product. Do not open the casing!
The fitting of hygiene covers to the cushions, may
affect the acoustic performance of the ear-muffs.
Always use original accessories.
Do not push the earmuffs against the helmet shell. If
you do that, it can cause cracks around the side of
the helmet.
(Fig. 5)
Do not put the product in storage at temperatures
above +55°C, for example on a dashboard. Do not
put the product in storage at temperatures below
-20°C.
The wearer should ensure that the ear-muffs are
fitted, adjusted and maintained in accordance with
this operator's manual.
word mark and logos are registered
Bluetooth SIG, inc. and any use of
221

Publicité

loading

Ce manuel est également adapté pour:

Hp310-1Hp310-2