Getting Started; Inserting The Batteries; Charging The Batteries - Pioneer VMS-550 Mode D'emploi

9 Charging contacts
Battery charging begins when these terminals come into contact with the
speaker's terminals.
10 DC IN jack
Connect the supplied AC adaptor to this jack. (Use only the supplied AC
adaptor. Using adaptors with different plug polarities or other characteristics
could cause malfunction.)
11 Transmission frequency select switch
Slide the switch to change the transmission frequency (CH1/CH2).
12 Input cord
Connect to the headphone output jack of a television or AV component.
13 Conversion cord
Connect this conversion cord to the standard input cord when you wish to
connect to the line output jack of a television or AV component.

2. Getting started

2-1 Inserting the batteries

1 Remove the battery compartment cover on the bottom of the speaker
(see illustration 2-1.1).
2 Confirm the "+'' and "–'' poles and insert the batteries.
3 Return the battery compartment cover to its original position.

2-2 Charging the batteries

1 Confirm the type of electrical outlet and securely connect the appropriate
adapter to the AC adapter body (see illustration 2-2.1).
2 Connect the supplied AC adaptor to DC IN jack on the transmitter.
Plug the adaptor into the wall outlet.
3 Connect the speaker and transmitter so that their charging terminals are
in contact. When charging begins, the speaker's CHARGE indicator will
light red, and when charging is completed the indicator will go out. The
time required for charging will vary depending on the amount of charge
remaining in the battery at the time charging began (maximum time
required approx. 8 hours). Maximum operating time with full charge is
approx. 16 hours (5 mW + 5 mW output).
Note
• Turn off speaker power before beginning recharging.
• Usage time may vary according to the temperature and other conditions.
• Maximum operating time may be shorter depending on sound volume used
and condition of battery.
• Even AC adaptors with the same voltage and plug polarity can damage this
product due to the current capacity or other factors.
• Use only the supplied AC adaptor. Using other adaptors with
6
En
different plug polarity or other characteristics can cause product
failure.