Setting The Alarm - Philips AJ3080/04Z Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 8
CLOCK
Adjusting the time
1. Adjust the CLOCK control to the TIME SET
position.
2. Press and hold down the H
set and adjust both the hours and the minutes.
– With your finger held down on H
will increase, shown as a digit from 00 to 23 .
– With your finger held down on M
minutes will increase, shown as a digit from
00 to 59 .
3. Release the H
or M
R
IN
reached the correct setting.
4. To safeguard the clock time from being
accidentally adjusted, turn the CLOCK control to
the RUN position.
6 : 45

SETTING THE ALARM

General
If you wish to use the alarm, then you should first
set the alarm time. There is a choice of two modes
for waking you up: by buzzer or radio.
The display also indicates whether you have
switched on the alarm, shown as a dot next to
ALARM in the display.
ALARM ON
1. Adjust the CLOCK control to the ALARM position.
2. Press and hold down the H
set and adjust both the hours and minutes.
– With your finger held down on H
will increase, shown as a digit from 00 to 23 .
– With your finger held down on M
minutes will increase, shown as a digit from
00 to 59 .
3. Release the H
or M
R
IN
reached the correct setting.
4. Adjust the CLOCK control to the RUN position to
return to clock time display.
– To review your set alarm time, adjust the
CLOCK control to the ALARM position.
or M
buttons to
R
IN
, the hour
R
, the
IN
button when you have
or M
buttons to
R
IN
, the hour
R
, the
IN
buttons when you have
5. To select the alarm mode you wish to be awoken
by, set the ALARM switch to
– If you have selected the radio mode, make
sure you have adjusted the volume loud
enough to wake you.
– The buzzer is set at a fixed volume and cannot
be adjusted.
ALARM OFF
You can switch off the alarm in three ways.
Unless you choose to cancel the alarm completely,
the ALARM RESET option will be automatically
selected after 1 hour and 59 minutes from the time
your alarm first goes off.
ALARM RESET
If you want the alarm mode to be stopped
immediately, but also wish to repeat the alarm call
at the same time for the following day:
• Press ALARM RESET during the alarm call.
REPEAT ALARM
This will repeat your alarm call at 9 minutes
intervals.
• Press
/REPEAT ALARM.
SLUMBER OFF
• Press
/REPEAT ALARM again during
SLUMBER OFF
the next call if you wish to repeat the alarm call.
• If, however, you do not press
ALARM again, the alarm will sound for 1 hour
and 59 minutes minutes before turning itself off.
Your alarm time setting will then automatically
enter the ALARM RESET mode to sound at the
same time next day.
Switching off the alarm completely
• Before or during the set alarm goes off, push the
ALARM switch to the OFF position.
– The alarm indicator will disappear from the
display.
CAJ3080/00 page 5
ALARM
or
.
RAD
BUZ
/REPEAT
SLUMBER OFF
5

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Aj3080/00z

Table des Matières