Mounting Instructions - JBL TempSet angle-connect Instructions De Montage

Mounting instructions:

What you will need:
Power drill with 20 mm HSS drill bits. Screwdriver.
The mounting procedure described in the following can be performed by anyone if the instruc-
tions are followed accurately. You do not need to be a specialist:
1. Drill a hole with a diameter of approx. 20 mm into the surface where you plan to mount your
TempSet kit. The surface should be flame-resistant or non-flammable.
2. Disconnect the quick coupling of the TempSet kit.
3. Loosen the locking screw on the pull relief located on the threaded tube. Screw the pull re-
lief off of the threaded tube, making sure not to twist the cable. Push the pull relief up along
the cable by approx. 10 cm. Loosen the upper hexagon nut on the threaded tube and push
it up along the cable to the pull relief like before. Then push the slotted washer up, too. The
washer can now be removed from the cable through the slot.
4. Insert the cable with the quick coupling, pull relief, loose nut and threaded tube through the
pre-drilled hole from the inside until it is closed off by the large washer that remains. Now
push the slotted washer beneath the pull relief along the cable again and secure it with the
hexagon nut that was loosened in Point 3.
5. Screw the pull relief back onto the end of the threaded tube and secure the cable with the
locking screw.
6. Screw the desired lamp (or spot lamp) into the socket. Make sure to hold the socket with
UK