Philips 9000 Série Mode D'emploi page 29

2
1
Cleaning the cleansing brush
2 Rinse cut hairs off the cutting unit with
lukewarm water.
3 Rinse cut hairs off the comb.
4 Remove the cutting unit from the beard styler
attachment. By pushing the cutting unit off the
beard styler attachment, you can remove any
hairs that have accumulated inside the beard
styler attachment. You can also rinse the
bottom of the cutting unit.
5 Rinse cut hairs out of the beard styler
attachment.
6 Carefully shake off excess water and leave the
comb, cutting unit and beard styler attachment
to air-dry before you use them again.
7 When the cutting unit is dry, attach it to the
beard styler attachment.
8 When the comb is dry, attach it to the beard
styler attachment.
9 For optimal performance, lubricate the teeth of
the attachment with a drop of sewing machine
oil regularly.
Clean the attachment after each use.
1 Switch off the appliance.
29
English