SKF SENSORMOUNT TMEM 1500 Mode D'emploi page 13

7. Apply additional pressure to correct
the reading if necessary.
8. Release the pressure from the
hydraulic nut.
9. Unscrew the hydraulic nut from the
shaft or sleeve.
10. Disconnect the cable of the
SensorMount Indicator from the
sensor.
11. Cut off the cable as close to the
sensor as possible, by using a pair of
cable clippers or a knife.
12. Install appropriate locking devices to
hold the bearing in place.
SKF TMEM 1500
®
SensorMount Indicator 13