Major Functions; Trouble Shooting - Maxx Ice MIM50 Manuel D'installation, D'instruction Et D'entretien

11/07/2017 PK

MAJOR FUNCTIONS

The operating procedure is completely automatic.
1.
When the ice storage bin is full of ice cubes, the ice maker stops making ice automatically. It starts making ice
2.
again after ice cubes are removed.
The different colors of the LED display indicate various work modes.
3.
A sensitive probe and accurate timer enhance the performance of the ice maker.
4.
A compressor protection system is built in.
5.

TROUBLE SHOOTING

Problem
The ice maker doesn't
operate.
The water doesn't feed
in after the ice maker
starts.
Ice maker makes ice,
but bin does not fill up
with ice.
Water is leaking out of
the unit.
Cubes are partially
formed or are white on
the bottom.
Noise during operation
The ice maker stops
suddenly while making
ice.
The body of the ice
maker is electrified
Scaling occurs
frequently inside the
ice maker.
Water leaks from the
ice storage bin.
Buzzer alarm.
(Applies to MIM50P and
MIM50P-O only)
Possible Cause
The ice maker is unplugged.
The fuse is blown.
The ice maker power button is set at OFF.
The ice storage bin is full of ice.
The water supply tap is turned off.
The water supply pipe is not properly connected.
The condenser may be dirty.
The air flow to the ice maker may be obstructed.
The ambient temperature and water temperature
are high, or unit is near some heat source.
Some water falls to the floor when you open the
door to remove ice from storage bin.
Water supply connection is leaking.
Drain pipe higher than drain outlet.
MIM50V/50/50-O only. MIM50P/50P-O has drain pump)
Not enough water in the water trough.
The feet are not leveled and locked.
Certain sounds are normal.
The electricity is off.
The room temperature is out of the stated range.
The ice storage bin is full of ice.
The ground line isn't in the socket.
The hardness level of the water is too high.
The drain hole below the ice storage bin is blocked. Remove the ice storage bin and clean the drain hole.
The drain hose is kinked or improperly placed
higher than the floor of the ice storage bin.
Problem in pumping out water.
Probable Correction
Plug the ice maker in.
Replace fuse. If it happens again, call for service to check
for a short circuit in the unit.
Switch the ice maker power button to ON.
Remove some ice cubes. Be sure the ice-full probe is free
of ice.
Turn on the water supply tap.
Reconnect the water supply pipe.
Clean the condenser.
Check the installation.
Check the installation.
Normal condensation on the door or some water
together with ice. Take care when you take out ice.
Tighten fitting. See Connecting the water line.
(Applies to
Lower drain pipe.
Check if the water supply pressure is below 15 psi (103
kPa).
Check water supply or filter may be restricted.
Check for a water leak at the water trough.
Level and lock the feet.
See Leveling the Ice Maker.
See Normal Sounds.
Reconnect the power supply line.
Cut off the electricity and leave the ice maker
disconnected until the temperature returns to within the
stated range.
Remove some ice cubes; make sure the ice-full probe is
free of ice.
Use a socket meeting the grounding requirements.
Install a water-softening device in front of the water
inlet.
Check the drain hose to be sure water can be drained
out unhindered.
Check for correct operation of drain water pump, water
level switch and drain tube.