Pairing The Remote Control - VelLight LEDC26 Mode D'emploi

 memory function: the device remembers the last used function on
power loss. On power restore, the last used function is automatically
activated.
 use only with a power supply of max. 60 W / 12 V or 120 W / 24 V
5. Overview
Refer to the illustrations on page 2 of this manual.
1. on-off/standby: press to switch the dimmer on or off, or to switch to
standby mode.
2. light mode: switch to light mode
3. + 8. + 9. dimmer pre-sets
4. + 6. dynamic mode: switch to dynamic mode or between different
dynamic modes
5. + 7. speed: dynamic mode speed adjustment
10. + 11. brightness: light mode brightness adjustment
6. Installation
Connect the power supply and LED strip according to the correct polarity. Do
not short circuit the LED output as this may permanently damage the
dimmer! Please do not install the dimmer in a metal casing or near large
metal objects.
7. Operation

7.1 Pairing the Remote Control

The dimmer and included remote control are paired by default. To pair a
new remote:
1. Remove the power supply to the dimmer, and reapply the power
supply after 5 seconds.
2. Wait for 5 seconds, aim the remote control to the dimmer.
Simultaneously hold [100%] and [25%] pressed for 5 seconds.
3. The remote control is paired to the dimmer.
7.2 Pairing the Remote Control to Several Dimmers
One remote can also be used to control several dimmers simultaneously. To
do so:
1. Remove the power supply to the dimmer, and reapply the power
supply after 5 seconds.
2. Wait for 5 seconds, aim the remote control to the dimmer.
Simultaneously hold [on-off] and [BRIGHT+] pressed for 5 seconds.
3. The dimmer will recognize any remote control.
V. 01 – 04/04/2016
LEDC26
4 ©Velleman nv