EIBENSTOCK EBW 2300 Notice Originale page 15

Declaration of conformity
It is necessary that the machine (e.g.: ETN 162/3) used in this drill rig comply with
the requirements which are described in the specifications of the drill rig (f. e.
drilling diameter, fixture of the motor).
We declare that this unit has been designed in compliance with 2006/42/EC.
This unit must not be put into service until it was established that the Power Tool
to be connected to this unit is in compliance with 2006/42/EC (identified by the
CE-marking on the Power Tool).
Vakuum Technik GmbH Eibenstock
Lothar Lässig
26.05.2016
14