NODOR Vinoteca V24B Manuel De L'utilisateur page 19

Attention
• Store wine in sealed bottles.
• Do not overload the cabinet.
• Do not open the door unless necessary.
• Do not cover shelves with aluminum foil or any other shelf
material which may prevent air circulation.
• Should the wine cooler be left empty for long periods it is
suggested that the appliance is unplugged, and after careful
cleaning, leave the door ajar to allow air to circulate inside the
cabinet in order to avoid possible condensation, mold or odors
forming.
• Replace the door gasket.
Installation of Your Wine Cooler Built-in
• The appliance is designed to be built in between (Door) kitchen
cabinets and is supplied with adjustable feet that can be altered
to fit various worktop heights. This wine cooler is fully compatible
with any 600mm deep kitchen unit.
• The air vent at the front of the appliance must never be covered
or blocked in any way.
• Avoid locating the unit in damp areas.
Electrical Connection
Check that the voltage marked on the product corresponds with
your supply voltage.
WARNING: Improper use of the grounded plug can result in
the risk of electrical shock. If the power cord is damaged, have
it replaced by a qualified electrician or an authorized service
center. This appliance should be properly grounded for your
safety. The power cord of this appliance is equipped with
a plug which mates with the standard grounded outlets to
minimize the possibility of electrical shock. Do not under any
circumstances cut or remove the ground prong from the power
cord supplied. For personal safety, this appliance must be
properly grounded.
Model V61B
This appliance requires a standard 220-240 Volt AC ~50Hz
electrical ground outlet. Have the wall outlet and circuit checked
by a qualified electrician to make sure the outlet is properly
grounded. When a standard 2 pins wall outlet is encountered,
it is your responsibility and obligation to have it replaced with a
properly grounded 3 pins wall outlet.
The cord should be secured behind the appliance and not left
exposed or dangling to prevent accidental injury. The appliance
should always be plugged into its own individual electrical outlet
which has a voltage rating that matches the rating label on the
appliance. This provides the best performance and also prevent
overloading house wiring circuits that could cause a fire hazard
from overheated. Never unplug the appliance by pulling the
power cord. Always grip the plug firmly and pull straight out from
the receptacle. Repair or replace immediately all power cords