NODOR Vinoteca V24B Manuel De L'utilisateur page 18

Digital Control Panel
Door
Handle
Shelves
Bottom Shelf
Adjustable Legs
Features of Your Wine Cooler (Built-in)
Installation Instructions
Before Using Your Wine Cooler
• Remove all exterior and interior packing.
• Before connecting the Wine Cooler to the power source, let it
stand upright for approximately 2 hours.
• This will reduce the possibility of a malfunction in the cooling
system caused by handling during transportation.
• Clean the interior surface with lukewarm water using a soft
cloth.
• The door on this appliance can be opened from either the left or
the right side. The unit is delivered with the door opening on the
left side. Should you wish to open the door from the right, follow
the instructions 'Reversing the door swing of your appliance'.
Installation of Your Wine Cooler
• The appliance is designed to be built-in the kitchen cabinets.
• The appliance should be positioned in a well-ventilated, dry
room.
• Place your Wine Cooler on a position that is strong enough to
support it when it is fully loaded. To level your Wine Cooler, adjust
the front leveling legs at the bottom of the Wine Cooler.
• Locate the Wine Cooler away from direct sunlight and sources
of heat (stove, heater, radiator, etc.). Direct sunlight may affect
the acrylic coating and heat sources may increase electrical
consumption. Extreme cold ambient temperatures may also
cause the unit not to perform properly.
Cabinet
• Plug the Wine Cooler into an exclusive, easily accessible plug
socket. Any questions concerning power and/or earthing should
be directed towards a qualified electrician or an authorized
products service centre.
• To prevent the appliance from heating up, ensure that an
adequate ventilation gap is retained and install a suitable thermal
insulation panel. An adequate flow of air to and from the cooling
system must be ensured.
• The appliance must be installed to all electrical, plumbing, water
and drain connections in
NOTE
: Make sure that the socket and ON/OFF
switch are easily
has been installed.
Built-in Cabinet Instructions
The wine cooler door seals the installed unit almost completely, so
an air vent must be provided in the base of the housing. Warmed
air must be conducted via the ventilation shaft to the rear wall of
the housing and then expelled upwards. The ventilation channels
should measure at least 200 square centimeters in cross-section.
1. Remove the door gasket on the side you wish to install the
handle - you can see two designated holes for handle installation.
2. Install the handle tightly as shown above with two screws, lock
washers and flat washers provided.
WARNING: To ensure the proper functioning of the appliance, air
vents should never be blocked or covered.
accessible after the appliance