Operating - Genesis GPS080 Manuel D'utilisation

OPEraTIOn
WarnIng:
voltage on the rating name plate.
WarnIng:
before adjusting, adding accessories, or checking a function on the tool.
ATTACHING SANDPAPER, SCRUBBING PAD (NOT INCLUDED) AND
POLISHING PAD (NOT INCLUDED)
The sander comes with a Hook and Loop Quick attaching pad. Align the pointed tip and rounded
edge of this sandpaper or a pad with the pointed tip and rounded edge of the Hook and Loop pad.
Carefully press the fuzzy side of the sandpaper against the pad as tightly as possible.
nOTE
: Sandpaper can be reused for the life of the sanding abrasive. It is
recommended that you keep the sandpaper backing pad clean to provide for
the best adhesion. Clean occasionally by brushing backing pad lightly with a
small brush.
To remove sandpaper and pads, simply pull the used sandpaper off the Hook & Loop
base and attach the desired sandpaper by pressing it onto the base of the sander.
SWITCH ACTION
CaUTIOn
: Before plugging in the tool, always check to see that the tool is
switched off.
The switch can be locked in "ON" position for ease of operator comfort during extended use. Apply
caution when locking tool in "ON" position and maintain a firm grasp on the tool. your sander is
equipped with a flexible plastic boot that covers the "ON/OFF" switch; this is referred to as a "dust-
protected switch". It is not uncommon for sanders to collect large amounts of airborne sawdust in
the switch area, which, if not cleared out, may cause the switch to become non-functional. The dust
protected switch, on the other hand, can not accumulate dust in the switch area.
To start the sander, press down the "I" (ON) side of the switch.
To stop the sander, press down the "O" (OFF) side of the switch.

OPERATING

• Connect the sander to power source.
• Secure the work piece by clamp or other device to prevent it from moving under the sander.
• Grasp sander tightly in front and away from you; keep it clear of the work piece. Turn on sander
and let motor build to its maximum speed. Slowly lower the sander onto the work piece. Move the
sander slowly across the work piece using small circular motions.
Do not force the tool. Let it do the work. Light pressure is all that is required for sanding,
polishing and scrubbing. excessive pressure will slow the motor, rapidly wear sandpaper, reduce
sander speed and produce inferior results. Any finish or resin on wood may soften from frictional
heat. Do not sand on one spot for too long, as sander may remove too much material, making your
surface uneven.
Extensive periods of sanding may tend to overheat the motor. If it this occurs,
turn sander off and wait until sandpaper comes to a complete stop, then remove it from the work
piece, and let it cool down before using it again.
Corner Palm Saner
Operator's Manual
always check that the power supply corresponds to the
always be sure that the tool is switched off and unplugged
GPS080