Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
• AC Adapter:
Input 100~240V AC / Output 24V DC
• Power consumption: 12W max
1.
Place the diffuser on a firm and flat place, in upright direction. Take off the
cover of diffuser, open the water reservoir by lifting the lid.
2. Connect the adaptor to the DC plug before filling water into the water tank.
•
Add water to the water tank with a suitable measuring cup until the water
level is at the marker.
•
Never fill the water tank directly from the water tap, it could cause damage
to the diffuser.
•
Do not operate without water. Turn off the diffuser when the water tank is
empty.
•
In case of water exceeding the marker guideline, pour out the excessive
water, avoiding the air outlet.
3. Add one or two drops of your favorite concentrated fragrance or essential
oil into the water. Avoid essence oil or fragrance drop on to the shell sur-
face, in case of machine paint peeling off.
4. Close the water reservoir with lid, then replace cover.
5. Connect the adapter to the DC plug and then connect the adapter to the
power source.
WARNING: Please do not exceed the max water line when
filling water in side, one or two drops of essential oil is enough
for 120 ml water!
1. Press the "MIST" Button to cycle through the following four-mode setting
(from OFF position):
•
Press once for Constant High Diffusion
(Light Indicator Color: Red)
•
Press again for Constant Low Diffusion
(Light Indicator Color: Green)
•
Press again for Intermittent Diffusion
(Light Indicator Color: Blue)
•
Press again for One-Hour Timing Diffusion
(Light Indicator Color: Yellow, stop automatically after one hour including
LED lights if on)
Any Time Press "MIST" Button and hold 1.5 seconds to turn mist off.
TECHNICAL SPECIFICATIONS
INSTALLATION
FUNCTION CHARACTERISTICS
14
Publicité
Table des Matières
