DeVilbiss Healthcare Drive TSE 120 Mode D'emploi page 12

EN
TSE 120 PLUS:
Push the top-mounting pin
together (I) as shown in the
photo and insert down into
the mounting holes of the
ceramic bowl (photo 6).
Place the rear of the support (B) on the ceramic bowl and
screw in the star screws (H) from above but do not tight-
en them yet. Align the rear of the support (B) in the cen-
ter on the ceramic bowl and tighten the star screws (H)
(photo 7+8).
7
I

8
C
H
Insert the adjustable holders (C) at the desired height
(8.5 / 12 / 15.5 cm) on the rear of the support (B) on the
right and left (photo 2).
To adjust the height in the front, insert the supports (D)
in the corresponding opening until they audibly click into
place (photo 3).
• Take care that the front supports (D) on the right and
left are each inserted at the same height.
• The front supports (D) can be set lower than the rear
support (B).
• Insert the two braces (E) in the corresponding open-
ings in the rear until they audibly click into place (photo
4).
• Insert body (A) of the raised toilet seat into the adjust-
able holders (C). In doing so, the adjustable holders (C)
must engage with the locking tabs (L) in the body (A)
(photo 4+5).
The adjustable holders (C) can only be inserted in one
direction into the raised toilet seat.
12
Drive Medical GmbH & Co. KG | As per: 24.03.2020 | Errors and alterations excepted
LID ASSEMBLY:
The lid is preassembled at the time of delivery, but can
be replaced if necessary. To do this, turn the body (A) of
the raised toilet seat around and press the lid clips at the
same time.
The lid can then be taken out of the holders. Clip the new
lid on.
ARMREST ASSEMBLY:
Push the armrests (J) sideways into the armrest holders
provided for this purpose (photo 9).
9
I
When doing so, the arrows on the armrest (J) and the
armrest holder should match up (photo 10).
10
C
H
B
Now push the armrests (J) in until they catch, and then
fold them down.
J
J
Instructions for use TSE 120 / TSE 120 Plus