Horizon Hobby Fat Shark Focal DVR FPV Manuel D'utilisation page 15

Head Tracking, continued
4. 4 short beeps: servo reversing
Long beep upon entering sub menu
1 short beep: reverse pan direction
2 short beeps: reverse tilt direction
3 short beeps: reverse roll direction
No selection: exit menu
5. 1 long beep: adjust servo center point: press to gain manual control of the camera
with the headset. Adjust camera to desired center position and press button to set
new camera center. Servos must be mechanically centered before adjusting the
center point, or the servo travel may be limited.
6. 1 short beep: pan ratio options
Long beep upon entering sub menu
1 short beep: ratio = 1:1
2 short beeps: ratio = 1:1.5
No selection: exit menu
7. 2 short beeps: tilt ratio options
Long beep upon entering sub menu
1 short beep: ratio = 1:1
2 short beeps: ratio = 1:1.5
No selection: exit menu
8. 3 short beeps: auto pause on/off (if head tracker movement exceeds 90˚, this
selection puts Head Tracker in pause mode)
9. 4 short beeps: extended servo travel options *
Long beep upon entering sub menu
1 short beep: standard range = 1.04 ms – 2.0ms (center = 1.52ms +/- 0.48)
2 short beeps: extended range = 0.8ms – 2.24ms (center = 1.52ms +/- 0.72)
No selection: exit menu
10. 5 short beeps: cycle time*
Long beep upon entering sub menu
1 short beep: standard cycle (8CH PPM, 20ms)
2 short beeps: rapid cycle (3CH PPM, 8ms)
No selection: exit menu
11. 6 short beeps: restore factory defaults
12. 2 long beeps: no selection made, automatically exits menu
* May cause erratic behavior with some radio systems. Recommended for advanced
users only. Test thoroughly before use.
15