Télécharger Imprimer la page

Using The Machine - EUROPASTYLE DB 2546 Mode D'emploi

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

47497-05-DB 2546 EST

Numbering of the Controls

1 Steam jet button

2 Steam regulator with self-clean function

3 Filler opening for the water tank

4 Spray nozzle

5 Spray button

•

Clean the ironing base with a slightly damp cloth.

•

The water tank (9) is filled through the replenishing hole (3) with cold water. If the

water is hard, please use distilled water. Use a replenishing container if necessary.

NOTE: Only clothes should to be ironed with this machine.

Ironing without Steam (Steam quantity regulator set to MIN)

1. Place the iron on its stand (7).

2. Electrical connection

Make sure that the iron voltage (see name plate) and the line voltage match.

3. Sort out the garments according to their ironing temperatures. Start with the

lower temperatures. It is set with the thermostat (8):

Synthetics, silk (low temperature)

Wool

Cotton, linen

4. Insert the plug into a socket with earthing protection.

5. The control lamp (6) lights up. As soon as it shuts off, the set temperature is

reached (approximately 3 min.). Now you can start to iron.

6. Always pull the plug out of the socket after using the iron.

Steam Ironing

For this a high temperature is needed (cotton, linen). The quantity of steam can be

regulated using the steam quantity regulator (2). Extra steam can be added with the

steam jet function (1).

Vertical Steam: This can be used to produce a jet of steam in a vertical direction.

Self-Cleaning

1. Half fill the water tank with water.

2. Heat the machine up to its maximum temperature. After the control lamp (6)

goes off remove the machine from the mains supply.

3. Now hold the machine horizontally above a sink, turn the steam quantity control

(2) to the self-cleaning symbol

When pressed and turned the control switch then returns to the

22.04.2002 11:14 Uhr

First Use of the Machine