SPL-Technik 310 Manuel D'utilisation page 6

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 14
Important: if the helicopter is always rotating, please
If the helicopter rotates during flight, follow the instructions below to stop the rotation.
The helicopter rotates counter clockwise.
Adjust the trimmer until the helicopter stops rotating.
The helicopter rotates clockwise.
Adjust the trimmer until the helicopter stops rotating.
ATTENTION!
The model helicopter is equipped with an in-built lithium polymer battery. When
using it, you must observe the following safety rules:
1.
Don't let the batteries fall from heights.
2.
Don't expose the batteries to blows on hard surfaces.
3.
Don't throw the batteries into a fire or into water and store them in a dry place.
4.
Use only the original charging device.
5.
Don't disassemble the battery.
6.
Don't leave the battery unsupervised when charging.
If the helicopter battery is discharged or the helicopter is used for a long time, the
power can automatically cut off. When this happens, the indicator on board the helicop-
ter twinkles and the helicopter is inactive. This is a normal occurrence with this model.
In case of automatic power cut-off due to lengthy use of the helicopter, move the gas
stick to the minimum position, switch off the helicopter's power, charge the on-board
battery and then switch on again: your helicopter will again be ready to fly. Attention! If
the gas stick is not in the minimum position, then the helicopter will immediately take off.
The flickering red indicator on the helicopter's control board tells you the transmitter
batteries are low. Change the batteries and resume flying.
use the trimmer to adjust the rudder.
Turn the trimmer clockwise.
Turn the trimmer counter clockwise.
6

Publicité

Table des Matières
loading

Table des Matières