Safety Rules - SPL-Technik 310 Manuel D'utilisation

Kit elements
Kit includes:
- Helicopter: 1 pce.;
- Transmitter with charge function: 1 pce.;
- Instructions: 1 pce.

Safety rules

1. Use batteries with voltage not less than 1.5 V. Low grade power supply elements
significantly reduce the device's operational range.
2. Keep the model and its components away from moisture. This can cause damage to
the electronics.
3. Before each flight, check the operational range of the device. Be sure that the model's
battery is fully charged and that the transmitter has fresh AA batteries.
When cleaning the model, do not use solvents. This can cause damage to the plastic parts
of the model.
4. When cleaning the model, do not use solvents. This can cause damage to the plastic
parts of the model.
5. It is recommended that you fly the model in spacious premises. This model is not
intended for flying outdoors.
6. Do not fly the model in places where people, especially children, are gathered, and
stay at least 15 metres away from devices which could interfere with the flight of the
model. Make sure that there are no foreign objects with which the model could collide.
7. Don't let the model fly too far away from you. The farther away it is, the more difficult
it is for you to correctly judge its position and behavior in flight.
8. Always point the optical sensors of the transmitter directly at the model.
9. Powerful sources of light, sources of infrared (IR) radiation and sunlight can substan-
tially influence the quality of the signal received from the IR transmitter. Do not send the
model flying in the direction of the aforementioned interference. Before each flight, be
certain there is no interference present.
10. When learning how to fly, it is recommended that you make flights at low altitude. In
case of pilot error, you can then easily reduce the gas and lessen the risk of serious
damage to the model.
11. In case of unforeseen emergencies or collision with some obstacle, immediately
switch off the engine. Never turn on the model if something obstructs the rotation of the
rotors.
12. Minimum dimensions of the premises used for flying: 5x5x3 metres, without any
draughts and directional air flows.
13. Take off only from a flat and smooth surface, starting out slowly and gradually raising
the rpms of engine.
14. Never hold the model with rotating rotors at the level of your face.
On/Off switch
Gas stick
Channel switch
Charging cable
3
Power
indicator
Turn right / leſt
Trimmer
Charge indicator