Table des Matières
Publicité
of steam to smooth out creases and freshen up materials while they are
hanging.
• Before ironing delicate fabrics it is best to make trial run on a hidden
piece e.g. the hem.
• We advise you to iron materials needing low temperatures first then go
on to more resistant materials, needing higher temperatures, afterwards.
WARNING!
• Some drops of water may leak out of the iron soleplate (11) when the jet
of steam starts coming out; this is quite normal and is due to
condensation forming inside the iron-boiler connecting tube. This will
disappear with the next jet of steam. It is therefore best not to point the
first jet of steam directly onto the item to be ironed.
• Never leave the iron unattended with the plug in the outlet when
you are ironing.
NO MORE WATER WHILE IT IS BEING USED
The jet of steam becomes less and finally disappears if there is no more
water.
The LED (4b) switches on to inform that the boliler has to be filled up
again.
Carefully follow the instructions given below to fill up the heater again:
• switch off the on/off boiler button (4) by turning it to "OFF" (O); the
integrated control indicator lamp will go off;
• press button (12) on the iron, until the boiler is completely empty and no
more steam is being produced;
• switch off the on/off button on the iron (3) by turning it to "OFF" (O) the
integrated control indicator lamp will go off;
• unplug the plug from the outlet;
• slowly unscrew the boiler cap (7) in an anticlockwise direction being
careful of any eventual residual steam;
• fill up the boiler following instructions given in the "How to fill the boiler
with water" paragraph;
• switch on the appliance again following the same instructions given in the
"How to start" paragraph.
WARNING!
Always unplug the iron from the outlet before filling the boiler with
water.
WHEN YOU HAVE FINISHED IRONING
• Switch off the boiler on/off button (4) by turning it to "OFF" (O).
• Empty out all the steam left in the boiler by pressing button (12) on the
iron.
• Switch off the on/off button (3) on the iron by turning it to "OFF" (O).
• Unplug the plug from the outlet.
• Rest the iron on the support base (5) and wait for the appliance to
completely cool down before putting it away.
WARNING!
Never unscrew the boiler cap (7) without emptying out all the steam
from the boiler.
FOR DRY IRONING
• Rest the iron on the boiler support base (5).
• Select the right temperature (see table in figure C) by turning the control
knob on the iron.
• Completely unwind the cord (9) and plug into the outlet.
• Press the on/off button on the iron (3) taking it to "ON" (I) the integrated
•
•
• ENGLISH
Publicité
Table des Matières
