Cleaning And Maintenance; Replacing The Fuse - EuroLite TS-155 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Control channel 5 - Shutter, strobe
DMX-value
Feature
0-14
Shutter closed
15
Open
16-250
Strobe-effect with increasing speed
251-255
Open
Control channel 6 - Gobo rotation
DMX-value
Feature
0-4
No rotation
5-120
Forwards gobo rotation with decreasing speed
121-139
No rotation
140-255
Backwards gobo rotation with increasing speed

CLEANING AND MAINTENANCE

The operator has to make sure that safety-relating and machine-technical installations are inspected by an
expert after every four years in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are inspected by a
skilled person once a year.
The following points have to be considered during the inspection:
1) All screws used for installing the devices or parts of the device have to be tighly connected and must not
be corroded.
2) There must not be any deformations on housings, fixations and installation spots (ceiling, suspension,
trussing).
3) The electric power supply cables must not show any damages, material fatigue (e.g. porous cables) or
sediments. Further instructions depending on the installation spot and usage have to be adhered by a
skilled installer and any safety problems have to be removed.
We recommend a frequent cleaning of the device. Please use a moist, lint-free cloth. Never use alcohol or
solvents!
The interior of the device should be cleaned at least annually using a vacuum-cleaner or an air-jet.
There are no serviceable parts inside the device except for the lamp and the fuse. Maintenance and service
operations are only to be carried out by authorized dealers.
Please refer to the instructions under "Installing/Replacing the lamps".

Replacing the fuse

If the lamp burns out, the fine-wire fuse of the device might fuse, too. Only replace the fuse by a fuse of
same type and rating.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Unscrew the fuseholder on the rearpanel with a fitting screwdriver from the housing (anti-
clockwise).
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
30/58
51786025_V_1_4.DOC

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ts-255

Table des Matières