Important Safety Instructions - König Electronic HC-EB10 Mode D'emploi

ENGLISH

IMPORTANT SAFETY INSTRUCTIONS

Read the instruction manual thoroughly and keep it for future reference. If the blanket is passed on to a third
party, please hand over these instructions as well.
Ensure you understand how this electrical blanket works en how to use it before you start using it.
Maintain the under blanket in accordance with the instruction manual.
Only use as UNDER BLANKET – Do NOT use as a duvet.
Do not tuck the blanket in.
The blanket must be placed on a relatively firm and non-adjustable mattress.
Do not use on a waterbed or a mechanically adjustable bed or sofa bed.
Do not use when folded.
Do not insert pins into the blanket.
Do not use if it is damp or wet.
Do not use if damaged in any way.
Ensure that the blanket is securely fixed to the mattress.
Only use the controller/s supplied with the blanket (model: KDA6-FT).
This blanket is not intended for medical use in hospitals.
Check that the controller/s and mains lead cannot become trapped in the bed or bedding.
Keep the controller/s outside of the bed at the pillow end and ensure it does not get covered – keep it in the
open so you can easily control the blanket.
Do not dry clean.
Do not tumble dry.
Do not use together with another heating appliance.
This under blanket is not intended for use by children or infirm persons without supervision or instruction
concerning use of the appliance by a responsible person.
Ensure that the person using the blanket is not insensitive to heat.
FITTING THE BLANKET
This blanket is intended to be used as an "UNDER BLANKET" and therefore should always be placed on a
relatively firm and non-adjustable mattress.
To help keeping the blanket clean and reducing wear, place the blanket under a bed sheet. Do not place it
under another blanket, mattress protector or similar product as these will greatly restrict the heat output.
The blanket must be fixed securely to the mattress using the tie loops on the blanket. The cord must be
threaded through the loops and passed under the mattress, finally being tied in a knot (a tight bow should
suffice so that it is easily undone to enable the blanket to be removed). Ensure, when fixing the blanket to the
mattress, that it will not move or crease.
The controller/s should be positioned at the top of the bed (pillow end) for optimal ease of use.
2