Panasonic TY-PG70LF50 Instructions D'installation page 19

3. Attaching the brackets to the display
3-1. Attach the brackets (large)
(small ) (2) to the cabinet fixing brackets of the
display with the supplied screws
the figures below.
(Tightening torque: 0.9 to 1.1 N • m)
Bracket (large)
Bracket
(large)
Screw
Bracket (small)
How to attach the brackets (large)
As shown in the ¿ gure, hook the bracket (large)
corresponding cabinet ¿ xing bracket.
How to attach the brackets (small)
As shown in the ¿ gure, hook the bracket (small)
corresponding cabinet ¿ xing bracket.
(8) and the brackets
(10), as shown in
Bracket (small)
Bracket (large)
Screw
to the
Screw
to the
4. Placing non-woven fabrics and
rubbers (thin) on the cabinet
4-1. Place the supplied six non-woven fabrics - non-woven
fabrics (long)
(4) - on the inner side surface of the cabinet.
4-2. Place the supplied six rubbers - rubbers (thin / long)
(2) and frubbers (thin / short)
surface of the cabinet.
Non-woven fabric (long)
Cabinet
Bracket
(large)
Cabinet
(lower side)
Non-woven
fabric (short)
The installed position of a PC
board in the lower side cabinet
Non-woven fabric
TY-PG70LF50
Rubber
Non-woven fabric
The rubber and non-woven fabric must
not stick out of the edge of the cabinet.
Non-woven fabric
Rubber
Placement
reference
(2) and non-woven fabrics (short)
(4) - on the inner front
Non-woven fabric
(short)
Non-woven fabric
(long)
Rubber (thin / long)
Rubbers (thin / short)
Cabinet (upper side)
Rubber (thin / long)
The center of the lower side cabinet
Non-woven fabric
TY-PG80LF50
Rubber
The rubber and non-woven fabric must
not stick out of the edge of the cabinet.
Non-woven fabric
Rubber
Placement
Placement
reference
reference
Cabinet
Non-woven fabric
Placement
reference
19