Technical Specifications; Machine Safety Warnings; General Safety Regulations - LEMAN TAB050 Manuel D'utilisation

9 Spur center CM2
10
Tool rest base
11 Toll rest 200mm
12 Lathe bed
13
Tool rest base locking lever
14 Electrical box
1.2 Technical specification
- Voltage / Frequency: 230 V / 1-50 Hz
- Motor power: 750 W – 1,0 CV
- Motor rotation speed: 2900 rpm
- Direction: Forward or Reverse
- Spindle speed: from 250 to 3850 rpm
- Spindle speed range: 3 (250-750 rpm + 550-1650 rpm + 1300-3850 rpm)
- Distance between centers: 510 mm
- Swing over bed diameter: 320 mm
- Indexing position: 24 positions
- Tool rest length: 200 mm (8'')
- Spindle taper: MT2
- Sleeve taper: MT2
- Spindle thread: M33x3,5
- Sleeve adjustment: 60 mm
- Packing size (Length x Width x Height): 985x525x315 mm
- Overall size (Length x Width x Height): 1200x253x445 mm
- Gross weight: 57 kg
- Net weight: 52 kg
- Working ambient air temperature range: from +5° to +40°
- Storage and transportation temperature range: from -15° to +55°.
- Emission sonore (suivant norme EN 60745): voir paragraphe 4.6
WARNING:
Read all safety warnings and all instructions. Failure to follow all warnings and instructions may result in
electric shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
Read the owner's manual carefully. Learn the tool's applications, work capabilities, and its specific potential
hazards.

2.1 General safety regulations

The manufacturer disclaims all responsibilities for damages to persons or things, which might be caused by any
failure to comply with the safety regulations.
CAUTION:
- Dusts from materials such as lead-containing coatings, some wood types, can be harmful to one's health.
Touching or breathing-in the dusts can cause allergic reactions and/or lead to respiratory infections of the user or
bystanders.
- Certain dusts, such as oak or beech dust, are considered as carcinogenic, especially in connection with wood-
treatment additives (chromate, wood preservative).
- Materials containing asbestos may only be worked by specialists.
- Prevent dust accumulation at the workplace; dusts can easily ignite.
- Provide for good ventilation of the working place.
- It is recommended to wear a P2 filter-class respirator.
- Observe the relevant regulations in your country for the materials to be worked.
- READ the entire Owner's Manual. LEARN how to use the tool for its intended applications.
- GROUND ALL TOOLS. If the tool is supplied with a 3 prong plug, it must be plugged into a 3-contact electrical
receptacle. The 3rd prong is used to ground the tool and provide protection against accidental electric shock. DO
NOT remove the 3rd prong.
GB

2. MACHINE SAFETY WARNINGS

23
- 1 Face plate Ø76mm
- 1 Spur center CM2
- 1 Live center CM2
Document:
- Instruction manual