ION Audio Air Lp Guide D'utilisation Rapide page 3

5. Raise / Lower Lever – Raises and
lowers the tonearm.
6. 33 / 45 / 78 Switch – This switch
controls the RPM of the turntable
platter.
Note: For best results when playing 78 RPM
vinyl records, use a 78 stylus (sold separately).
Only use a 78 stylus with 78 RPM vinyl records.
Purchase the
ionaudio.com/ict06rs.
7. Autostop switch – This switch turns autostop
on or off. When autostop is on, the platter will
start spinning when the tonearm is placed over
the record and stop spinning when the record
has reached the end. (When autostop is off, the
platter will always spin regardless of the
position of the tonearm.)
Note: If your vinyl record stops before it
reaches the end of the music, turn Autostop to
the off position for this particular record. This is generally recommended for 45 RPM
records.
8. Headphone Jack – Connect headphones (sold separately) to listen to your vinyl
playback.
9. Bluetooth Button – Press this button to start Bluetooth pairing. If after 5 minutes no
Bluetooth speaker can be found to pair with, the Bluetooth transmitter will become
inactive, and the LED will turn off. If currently connected, press this to disconnect from a
currently connected Bluetooth device.
10. Bluetooth LED – This LED blinks when pairing with a Bluetooth device. Once fully paired,
the LED will remain solid. The LED will be off when Bluetooth is inactive, and when the Air
LP is turned off.
11. Volume – Adjust this to control the headphone level.
12. RCA Output* – The audio from a playing vinyl record is sent to this line-level RCA audio
output. This must not be connected to phono level devices.
13. USB Audio Output – Use the included USB cable to connect your turntable to your
computer. The USB connection will send audio from the turntable to your computer.
Please see the Using Air LP With Your Computer section of this manual for information.
14. Power Cable Input – Use the included adapter to connect to wall power.
15. Power Button – Press this button to turn Air LP on/off. Air LP Turntable will re-connect to
your last used Bluetooth Speaker when powering on, if it is in range.
16. Aux Input – Connect a CD player, digital media player, or other audio source to this 1/8"
stereo auxiliary input. The audio from the Aux Input is also transmitted over a Bluetooth
connection.
iCT06rs 78 stylus
12 13
IMPORTANT: Place the included felt
slipmat on the platter; then place your
record on the felt slipmat to carefully hold
your records.
at
IMPORTANT:
cartridge cover (needle cover) before
operating the turntable.
*WARNING: The RCA outputs are LINE
level. Please only connect these to LINE
level inputs. You may damage your
receiver if you plug in a LINE level device
into a PHONO level input.
3
14
16
15
Remove the plastic