Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4.4. Removal and Replacement of Discs
• Turn the knurled handle and lift the cover. (Figure 1)
• Turn the disc counterclockwise and cover the cutting edge with appropriate material (rubber, fabric, etc), then lift it
by setting your hand under the disc.
• Lift the discs to remove the grid disc for dice cutting, or the disc for stick cutting with the plastic disc. (Figures 4-5).
5.1. General Information and Cleaning Recommendations
• Before carrying out any cleaning or maintenance operations, ensure that the mains switch is off and the supply
plug is disconnected from the mains.
• Clean the equipment and the discs every day for optimal operation and life of the equipment.
• The discs, the dicing grid, and the plastic ejector can be removed and washed under a warm water jet. Clean the
machine and the disc positions with a cloth or a sponge wet with warm water. Remove all debris to ensure the
discs sit properly.
•
Open the cover and loosen the 2 pins as shown in figure 6.
• Clean the surfaces with soap and water, alcohol and/or detergents without abrasives or chlorine/soda-based
substances (chlorine water, muriatic acid).
• Never use abrasives, steel wool, or similar products as they may damage the finish and compromise product life.
5.2. Failure to Start
When the white pilot light on the panel in on, but the machine does not start, check to ensure that the handle and
the cover are closed. In the closed position, both the safety micro-switches are on; these safety micro-switches
prevent the unit from starting in unsafe conditions. In the case of unit failure, the unit should only be serviced by
qualified personnel.
(Figure 4)
5. CLEANING, MAINTENANCE AND STORAGE
(Figure 5)
Remove the cover and wash underneath a water jet.
(Figure 6)
7
Publicité
Table des Matières
