Kemot PROsinus-300 Mode D'emploi page 21

is higher than 25° C, the battery needs to be recharged every 2 months for at least 12
hours.
CLEANING
Clean this device with soft, dry cloth. Do not use any chemical agents to clean this
product. Before cleaning, make sure the device is switched off and disconnected from
the power supply.
SPECIFICATIONS
Nominal power
Battery voltage
Overvoltage protection point
AC Input voltage
AC Input frequency
AC Output voltage
AC Output frequency
AC Output waveform
AC output efficiency
Charge current
Conversion time
Protections
Environment temperature
Environment humidity
Specifications are subjects to change without prior notice
English
Correct Disposal of This Product
(Waste Electrical & Electronic Equipment)
(Applicable in the European Union and other European countries with separate collection systems) This marking
shown on the product or Its literature, indicates that It should not be disposed with other household wastes at
the end of its working life. To prevent possible harm lo the environment or human health from uncontrolled waste
disposal, please separate this from other types of wastes and recycle it responsibly to promote the sustainable
reuse of material resources. Household users should contact either the retailer where they purchased this
product, or their local government office, for details of where and how they can take this item for environmentally
safe recycling. Business users should contact their supplier and check the terms and conditions of the purchase
contract This product should not be mixed with other commercial wastes for disposal.
Made in China for LECHPOL ELECTRONICS sp. z o.o. sp.k., 1 Garwolińska Street, 08-400 Miętne.
Owner's manual
Model PROsinus-300 PROsinus-500 PROsinus-700 PROsinus-1200
300 W
Overload, short circuit, overvoltage, undervoltage
500 W 700 W
12 VDC
15 VDC
180~275 VAC
45~60 Hz
230 VAC ±8%
50/60 Hz ±0.5 Hz
Pure sine wave
≥ 85% (DC to AC)
Max. 10 A
≤ 4 ms
0-40° C
10-90%
1200 W
EN
21