Lcd Display Information; Using The Twintalker 4700; Turning The Unit On/Off; Adjusting Speaker Volume - UCOM TwinTalker 4700 Manuel D'utilisateur

UCOM Twintalker 4700

12 LCD Display information

15
26
TX
RX
25
+
24

13 Using the Twintalker 4700

13.1 Turning the Unit ON/OFF

Monitor Monitor
TX
RX
APO VOX VOX
+

13.2 Adjusting Speaker Volume

Monitor Monitor
TX
RX
APO VOX VOX
+

13.3 Receiving a Signal

The unit is continuously in the RECEIVE mode when the unit is switched ON and not
transmitting.
In order for other people to receive your transmission, they must
also be on the same channel and have set the same CTCSS code.
(See 13.5)
10
16 17
Monitor
18
19
20
APO VOX VOX
23 22 21
To turn ON:
• Press and hold the
LCD display will display the current channel.
To switch OFF
• Press and hold the
LCD display will turn blank.
• Press the
speaker volume. The volume level is displayed.
• Press the
15. Channel number / Volume level indication
16. Monitor icon
17. Roger Beep icon
18. CTCSS code
19. Call Tone icon. Displayed when sending a
call tone
20. VOX icon
21. Key pad lock icon
22. Auto Power Off icon
23. Scan icon. Displayed during the CHANNEL
SCAN mode.
24. Battery level indication
25. RX icon. Displayed when receiving
26. TX icon. Displayed when transmitting
- button
- button
- button 10 in stand-by-mode to increase the
5
- button to decrease the speaker volume.
13 . The unit will "beep" and the
13 . The unit will "beep" and the
UCOM Twintalker 4700