NEC MultiSync E657Q Manuel D'utilisation page 63

DEFAULT GATEWAY
DNS PRIMARY
DNS SECONDARY
AMX Settings
Click on "AMX" on the left column below HOME.
AMX BEACON
CRESTRON Settings
Click on "CRESTRON" on the left column below HOME.
CRESTRON ROOMVIEW compatibility The monitor supports CRESTRON
ROOMVIEW, allowing multiple devices connected in the network to
be managed and controlled from a computer or a controller.
For further information visit http://www.crestron.com
ROOMVIEW
CRESTRON CONTROL
CONTROLLER IP
ADDRESS
IP ID
HINT: The CRESTRON settings are required only for use with
CRESTRON ROOMVIEW.
For further information visit http://www.crestron.com
Set your default gateway for the monitor connected to
the network when [Off] is selected for [DHCP].
NOTE: Set as [0.0.0.0] to delete the setting.
Enter the primary DNS server settings of the network
connected with the monitor.
NOTE: Enter [0.0.0.0] to delete the setting.
Enter the secondary DNS server settings of the
network connected with the monitor.
NOTE: Enter [0.0.0.0] to delete the setting.
To turn on or off for the detection from AMX Device
Discovery when connecting to a network
supported by an AMX's NetLinx control system.
HINT:
When using a device that supports AMX Device
Discovery, all AMX NetLinx control systems will
recognize the device and download the appropriate
Device Discovery Module from an AMX server.
Selecting [ENABLE] AMX Device Discovery will
detect the device.
Selecting [DISABLE] AMX Device Discovery will not
detect the device.
ROOMVIEW for managing from the computer.
ENABLE: Enables ROOMVIEW.
DISABLE: Disables ROOMVIEW.
CRESTRON CONTROL for managing from the
controller.
ENABLE: Enables CRESTRON CONTROL.
DISABLE: Disables CRESTRON CONTROL.
Sets the IP address of the CRESTRON SERVER.
Sets your CRESTRON SERVER IP ID.
Français-61