iPECS LDP-9200 Série Guide Rapide page 4

LDP-9208D/9224D/9224DF/9240D
installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.

Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 /RSS-GEN of the FCC/IC rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference; and (2) This device must accept any interference
received, including interference that may cause undesired operation.
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
This Class B digital apparatus meets the requirements of the Canadian Interference-Causing Equipment
Regulations, CAN ICES-3(B)NMB-3(B)
Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel
brouilleur du Canada.
The use of this device in a system operating either partially or completely outdoors may require the user
to obtain a license for the system according to the Canadian regulations.
CAUTION: Any changes or modifications in construction of this device which are not expressly
approved by the party responsible for compliance could void the user'sauthority to operate the
equipment.
ATTENTION: Tout changement ou modification dans la construction de cet appareil qui ne sont pas
expressément approuvé par la partie responsable de la conformité pourraient annuler l'autorité de
l'utilisateur à utiliser l'équipement.
1. When the crossed-out wheeled bin symbol is attached to a product, it means
the product is covered by the European Directive 2012/19/EC.
2. All electrical and electronic products should be disposed of separately from
the municipal waste stream via designated collection facilities appointed by
government or the local authorities.
The correct disposal of your old appliance will help prevent potential negative
consequences for the environment and human health.
4. For more detailed information about disposal of your old appliance, please
contact your city office, waste disposal service or the shop where you purchased
the product.
Disposal of your old appliance
Guide rapide