FireWare Cirrus Mode D'emploi Utilisateurs page 15

User Manual
EN
FireWare Cirrus
NEVER place objects (cloth, etc) over the smoke unit when it is in use as the smoke unit is
hot and can cause burns and fire.
Ensure that the machine does not overheat.
Extremely hot drops of fluid can sometimes escape from the nozzle during smoke
generation. So never aim the smoke generator at someone and keep a 3 meter distance
from the nozzle.
NEVER drink the smoke liquid. Keep it out of reach of children. In case of contacts with
the eyes immediately rinse with plenty of water and consult a doctor. Contact a doctor if
someone has ingested the smoke liquid. Show your doctor the packaging of the smoke
liquid.
Make sure you do not breath in the fumes of the liquid; this will damage your health.
When the liquid has been placed in the smoke unit the bottle with smoke liquid needs to
be sealed off immediately.
Make sure the ventilation channels are always unobstructed.
PLEASE NOTE: Smoke from this machine can activate your smoke detector.
Spilled fluid or drops from the machine can be slippery. Swab up the fluid immediately to
prevent accidents. Also note that, vapour and moisture on the machine can damage the
electronics.
NEVER run the machine without any fluid, as the pump will run dry.
The smoke unit works on 12 V; as a result it requires a special smoke liquid.
For your own safety you need to disconnect the appliance before filling up the
smoke liquid.
Do not subject the battery to temperatures below 0˚C.
The following warnings apply during recharge, besides those mentioned above:
Only use the appliance in plugs with an earth connection, maximum 220-240 Volt.
Never let the power-cord come into contact with other cables. Handle the power-cord and
all connections with the mains with particular caution.
Always disconnect power from the mains, when the device is not used or before cleaning.
Only handle the power-cord by the plug. Never pull out the plug by tugging the power-cord.
www.FireWare.nl
Afbeelding 2
FireWare Cirrus
15