Jacob Jensen Hygrometer II Silver Version Manuel D'utilisation page 25

For changing the battery, release the bottom lock by pressing the
hook towards you (use a small and flat screwdriver to handle the lock).
Keep the lock in released position while sliding the sensor upwards.
Note: The sensor is not to be mounted on metal frames.
To .set .up .the .hygrometer
1. Remove the battery compartment lid.
2. Insert the batteries, matching the poles (+/-), see Fig. 2. On initial set-up,
simply remove the plastic strip in the battery compartment.
. Press RESET after each battery change.
Data transmission will align automatically,
when the unit is turned on for the first
time or after replacement of batteries.
If "No Link" remains on the screen,
press RESET on both the sensor and the
main unit to re-establish communication
between the sensor and the main unit.
TIP: The transmission range may vary
depending on many factors. You may
need to experiment with various
locations to get the best results.
To .change .the .channels .once .a .channel .has .been .assigned
1. Slide the channel switch on the sensor to the desired channel.
2. Press RESET on the sensor.
. Press RESET on the main unit.
DISPLAY .
The bar chart is the default display.
The display gives a clear picture of the
outdoor / indoor humidity at a glance.
To .view .the .digit .display .temporarily
Press the centre button HYGROMETER
to transform the bars into actual digits
and to activate the backlight. Press
again to extend the display period.
To .view .the .digit .display .continuously
1. Press the centre button
HYGROMETER.
2. When the digits are displayed, .
slide the button DISP LOCK to ON
(in the battery compartment)
To .toggle .between .the .data .displayed . .
(up .to .three .multi .sensors .can .be .
connected) .– press HYGROMETER
– press CHANNEL.
Memory
To .view .the .maximum .humidity . .
recorded .
– press HYGROMETER – press MAX.
Humidity .Scale
25