Hach IO9000 Instructions D'utilisation page 6

Figure 1 Product components
1 IO9000 module
2 Mounting brackets
Installation
This instrument is rated for an altitude of 2000 m (6562 ft) maximum. Although the use of this
equipment above the 2000 m altitude does not show any substantial safety concern, the
manufacturer recommends that users with concerns contact technical support.
Install the brackets
Install the brackets as shown in the illustrated steps that follow.
Mount the instrument
Damage to internal components can occur if a screw goes into the side of the refrigerated sampler more than
12.5 mm (0.5 in.). Use the screws supplied to prevent damage to the refrigerated sampler.
Attach the I/O module to a flat, vertical surface that lets the user easily disconnect the I/O module
from the AS950 controller. Make sure that the I/O module is sufficiently near the sampler to connect
the I/O module cable to the AUX I/O port. Refer to
Refer to Figure 3 to attach the I/O module to the sampler.
6 English
3 Self-drilling screws
4 Screws for mounting brackets
N O T I C E
Figure 2 to attach the I/O module to a wall.