Starting A Route; Stopping The Route; Following A Route; Using My Route - Garmin Map Pilot Manuel D'utilisation

4
Select an option:
• Select Location Details to display details of your selected
location.
• Select Points of Interest to browse for businesses and
attractions near the current map section.
• Select Layers to select which map layers to display on the
map. You can select any combination of Traffic, 3D
Buildings, 3D Terrain, and POI.
• Select Rotate Mode to enable a rotated view of the map.
• Select View Toggle to view the map in 3-D or 2-D North
Up.
• Select Set Location to set your current location. You can
maneuver the controller over the map to find specific
locations.
NOTE: You must have your MAP PILOT set to GPS
Simulator mode and you must not be navigating a route
to set your location (Using the GPS Simulator, page

Starting a Route

1
Search for a location (Finding a Location by Category,
page 3).
2
Select a location.
3
Select Go!.

Stopping the Route

From the main menu, select Stop Route.

Following a Route

The route is marked with a blue line. A checkered flag marks
your destination.
As you travel, the device guides you to the destination with voice
prompts, arrows on the map, and directions at the top of the
map. If you depart from the original route, the device
recalculates the route and provides new directions.

Using My Route

While navigating a route, you can view turns for the route, add
waypoints, or take a detour.
1
While navigating a route, select Destination Entry > My
Route from the main menu.
2
Select an option:
• Select Turn List to view the turns on the route.
• Select Detour to take a detour on the route.
• Select Add Waypoint to add another point on the route.
• Select Map Preview to view the route.
• Select Auto Arrange to automatically arrange the
waypoints.
MAP PILOT Owner's Manual
• Select a waypoint to Reorder, Delete, or View Details of
the waypoint.
NOTE: Map Preview, Auto Arrange, and waypoint options
are available only when at least one waypoint has been
added to the route.
Adding a Waypoint to a Route
1
While navigating a route, select Destination Entry > My
Route > Add Waypoint.
2
Search for the location.
3
Select Add to Route.
4
Select Go!.

Taking a Detour

While navigating a route, you can use detours to avoid obstacles
ahead of you, such as construction zones.
NOTE: If the route you are currently navigating is the only
reasonable option, your system may not calculate a detour.
From the main menu, select Detour.
Using Advanced Detours
You can take a detour for a specified distance along your route
or detour around specific roads. This is useful if you encounter
construction zones, closed roads, or poor road conditions.
1
Select Settings > Navigation > Advanced Detours.
2
From the main menu, select Detour.
3
Select an option:
4).
• To detour your route for a specific distance, select a
distance.
• To detour around a specific road on the route, select
Detour by Road(s) on Route.
NOTE: If the route you are currently navigating is the only
reasonable option, your system may not calculate a detour.
Removing Detours
From the main menu, select Detour > Remove all detours.

Avoiding Road Features

You can select road features to avoid, such as toll roads or
unpaved roads.
1 Select Settings > Navigation > Avoidances.
2 Select the road features to avoid on your routes.
Your selections are automatically saved.
If certain road features cannot be avoided when calculating a
route, your system displays a message letting you know which
features are included in the route.

About Exit Services

When driving on a major highway, you can find gas, food,
lodging, and rest areas near upcoming exits.
Finding Exit Services
1 Select Destination Entry > Exit Serv..
2 Select an upcoming exit
3 Select a service type
.
.
5