Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
oPerAtion - Dry vacuum cleaning
Use the hand-held vacuum cleaner only when the filter (10)is correctly fitted (see 'Cleaning the
filter'). A damaged or incorrectly-fitted filter can cause damage to the appliance.
1. Make sure the hand-held vacuum cleaner's batteries are charged (see Charging the batteries).
2. If so required, fit an accessory to the appliance (see 'Fitting the accessories').
3. Switch on the appliance by sliding the On/Off switch (7) forwards.
4. Switch off the appliance after use by sliding the On/Off switch back.
5. After use, return the appliance to the charging holder.
oPerAtion - Wet vacuum cleaning
•
Use the hand-held vacuum cleaner only when the filter holder is correctly fitted (see 'Cleaning the
filter'). A damaged or incorrectly-fitted filter can cause damage to the appliance.
•
Do not use the appliance to suck up solids and liquids either at the same time or after each other.
•
The level of liquid in the dust-liquid receptacle may not rise above the 'MAX.' level.
•
Do not hold the hand-held vacuum cleaner vertically upright or downwards, to prevent liquid from
entering the appliance. Empty any liquid in the dust/liquid receptacle before returning the appliance
to the charging holder.
1. Make sure the hand-held vacuum cleaner's batteries are charged (see Charging the batteries).
2. Fit the rubber attachement to the appliance (see 'Fitting the accessories').
3. Switch on the appliance by sliding the On/Off switch (7) forwards.
4. Switch off the appliance after use by sliding the On/Off switch back.
5. Empty the liquid from the dust/liquid receptacle
6. After use, return the appliance to the charging holder.
oPerAtion - Fitting the asseccories
The hand-held vacuum cleaner is supplied with the following accessories:
•
a crevice tool (12), which you can use to clean radiators, window frames, crevices, small openings,
and similar;
•
a nozzle with brush (13), which you can use to clean delicate or irregular surfaces;
•
a nozzle with Rubber attachement (14), which you can use to suck up liquids.
oPerAtion - Fitting the Fitting the crevice tool and nozzle with brush
1. Hold the hand-held vacuum cleaner by the handle.
Make sure you cannot accidentally switch on the
appliance.
2. Slide the small nozzle into the nozzle of the
hand-held vacuum cleaner's dust/liquid receptacle.
3. If so required, slide the nozzle with the brush onto
the crevice tool.
oPerAtion - Fitting the Fitting the nozzle with rubber attachement
1. Hold the hand-held vacuum cleaner by the handle.
Make sure you cannot accidentally switch on
the appliance.
2. Slide the nozzle with the Rubber attachement
into the nozzle of the hand-held vacuum cleaner's
dust/liquid receptacle.
24
instruction manual
Figure 3
Figure 4
Publicité
Table des Matières
