General Points; Important Notes; Minimum Clearances - Olsberg Confort Notice D'utilisation

General points

Olsberg electric convector units can be used in many
different direct-heating applications. Their elegant
shape, ease of operation, high heating capacity and
reliability all serve to make them a cut above the rest.
These convector units are fitted with operating switch-
es and temperature regulators, thus making them ide-
al as frost-prevention devices.
Please note that the manufacturer can accept no lia-
bility whatsoever in the event of failure to observe the
instructions given below. These devices must not be
used for any purpose other than that for which they
have been designed.
The packaging on you high-performance Olsberg unit,
which has been kept to a bare minimum to avoid
waste, consists mainly of recyclable materials.
All items of packaging and unit components are identi-
fied where legally stipulated and/or possible in order
to make eventual scrapping, recycling or disposal eas-
ier.
Note: Ensure that all packaging materials, dis-
carded replacement parts and (eventually)
the unit itself and its components are cor-
rectly disposed of.
Disposal of old heaters
Old electric and electronic devices often
contain valuable materials. But they may
also contain harmful ingredients which
were necessary for their function and secu-
rity. In normal waste disposal or incorrect
treatment they could be harmful to the en-
vironment. Please help to protect our envi-
ronment! Please do not add your old heat-
er to normal waste in any case. Dispose of
your old heater according to the local regu-
lations.
10

Important notes

• Olsberg electric convector units are designed to
conform to all relevant safety standards and regu-
lations.
• Ensure that national standards are observed.
• Local safety regulations should also be taken into
account.
• Observe the international safety regulations re-
garding minimum clearances when installing the
unit in rooms equipped with bath or shower.
• When installing the device in a bathroom, ensure
that no switch or other operating control can be
reached by a person in the bath or shower.
• The temperature regulator cannot be used to dis-
connect the device from the mains supply.

Minimum clearances

Safety considerations require that the following mini-
mum clearances be maintained with respect to items
of furniture and other inflammable objects:
• From cover ..........................10cm
• From side panels.................10cm
• From floor ............................15cm
• From front panel ..................50cm
(hot-air outlet)
The wall-fixing bracket creates a rear-panel clearance
of 22mm.