Bradley 2903-280000 Manuel D'installation Et D'utilisation page 5

LISTA DE PIEZAS BÁSICAS
Descripción
Carcasa de hierro fundido, automático - Blanco
Carcasa de hierro fundido, Pulsador - Blanco
Motor - UL
Motor - CE
Resistencia - UL
Resistencia - CE
Temporizador - UL
Temporizador - CE
Sensor - UL
Sensor - UL
Escobillas
Turbina
Fusible - UL
Llave
Silent Blocks
Muelle del motor
Cable del sensor
1
15
Número de referencia Código de pieza Bradley
1 P15-420
2 P15-421
3 P15-422
3 P15-423
4 P15-424
4 P15-425
5 P15-426
5 P15-427
6 P15-428
6 P15-429
7 P15-417
8 P15-430
9 P15-431
10 P15-419
11 P15-444
12 P15-446
13 P15-447
3
5
7
6
10
9
2
11
12
METHOD OF USE
Sensored models
These models operate by hand detection. Place hands 2-6 inches (5 - 15 cm) from the
air outlet and the dryer will start working. Once activated, immediately place hands in
air flow and rub together until dry. This machine will stop 2-3 seconds after use.
NOTE: Vandal Resistant Operating System will cause this unit automatically shut-off if
sensor is completely blocked.
Push Button models
These models operate by push button activation. Once activated, immediately place
hands in air flow and rub together until dry. The dryer cycle time lasts 34 seconds, if
additional time is needed, push button to activate unit again.
PREVENTATIVE MAINTENANCE AND CLEANING
1. Preventative maintenance
Correct cleaning of the unit will lengthen its working life considerably.
When in use, the machine will accumulate dust inside which should be cleaned out every six months.
2. Cleaning Method
1. Turn off power to the unit.
2. Remove cover using security wrench (See Dismantling for Installation).
3. Clean away any accumulated dust on the fan with a soft bristle brush while rotating it manually. Use
the same brush, to clean away all accumulated dust from the other components. Carefully remove
any dust from the electronic circuit board and hand detecting sensors using a fine brush.
4
4. Use brush to clean the air inlet grill and make sure the LED visor is completely clean.
5. Check the condition of the motor brushes. These should be replaced when they are less than 13/64
inches (5 mm.).
6. Reconnect power to the unit and let it run continuously, removing any excess dust.
7. Turn off power to the unit and install cover per the Mounting Instructions.
Cleaning the cover - Use only a wet cloth to clean the covers. Do not use any kind of detergent, acids,
lye, abrasives, hydrocloric acid, etc.
8
WARRANTY
For Warranty information go to:
13
www.bradleycorp.com/customerservice/warranty-dryers.jsp
Caution: Do not damage or force any components.
www.bradleycorp.com
Sensored
Push Button
4