Information; About Ce And Doc; Disposal; Technical Information - Icom IC-SAT100 Notice De Base

Masquer les pouces Voir aussi pour IC-SAT100:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

6

INFORMATION

■ About CE and DOC

the product, comply with the essential
requirements of the Radio Equipment
Directive, 2014/53/EU, and the restriction
of the use of certain hazardous substances
in electrical and electronic equipment
Directive, 2011/65/EU. The full text of the
EU declaration of conformity is available at
the following internet address:
https://www.icomjapan.com/support/

■ Disposal

The crossed-out wheeled-
bin symbol on your product,
literature, or packaging reminds
you that in the European Union,
all electrical and electronic
products, batteries, and accumulators
(rechargeable batteries) must be taken
to designated collection locations at the
end of their working life. Do not dispose
of these products as unsorted municipal
waste. Dispose of them according to the
laws in your area.

■ Technical Information

• Output Power:
• SAR 10g:

■ Certification

Refer to the "Certification" screen for
certifications acquired with the transceiver.
([OK] > Information > Certification)
13
Hereby, Icom Inc. declares
that the versions of IC-
SAT100 which have
the "CE" symbol on
7 W
4.46 W/kg
Certification

■ FCC information

This device complies with part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
1.
This device may not cause harmful
interference, and
2.
This device must accept any
interference received,
Including interference that may cause
undesired operation.
This equipment has been tested and found
to comply with the limits for a Class B
digital device, pursuant to part 15 of the
FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and
can radiate radio frequency energy and,
if not installed and used in accordance
with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the equipment off and on, the
user is encouraged to try to correct the
interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/
TV technician for help.
CAUTION: Changes or modifications to
this transceiver, not expressly approved
by Icom Inc., could void your authority
to operate this transceiver under FCC
regulations.

Publicité

Table des Matières
loading

Table des Matières