VEVOR FLO500-DE Pro Manuel D'utilisation page 7

Some malfunctions of the grinder are not practically serious. You can
correct it by yourself. To diagnose and find a solution to the Trouble, refer
to the diagram below. For other malfunctions, get contact the supplier or a
qualified professional.
MALFUNCTIONS
The appliance occasionally
starts to work
The motor is running properly,
but the water runs slowly
away.
The engine is running
properly but non-stop or runs
for a long time
The motor is not switched on
The motor rattles with a noise
The motor is buzzing and
does not rotate
TROUBLE SHOOTINGS
POSSIBLE CAUSES
The connected pipelines are
leaking
The check valve is leaking
The aerator in the lid is blocked
The height or length of the drain
is too large,or too many bends
are used(power failure)
The pump is blocked
The power supply is not
switched on
The plug is defective
The trouble with the motor or
sensor
There's a strange object in the
motor
The condensator is broken or has
trouble with the motor
There's a strange object in the
Remove the lid,clean it and
motor
- 6 -
SOLUTIONS
Check the installation in front
of the appliance
Clean or replace the check valve
Clean the aerator
Check the installation
Turn off the power,
disassemble the pump and
unblock
Switch the on power supply
(repeat)
Repair the plug
Remove the lid,flush clean,and
dry the sensor up(hair dryer)
Remove the lid,clean it and
remove the object
Get in contact with a qualified
specialist or the supplier
Remove the lid,clean it and
remove the object