Yamaha GT-5000 Mode D'emploi page 18

Note
• Connect the turntable to the XLR balanced input jacks
on your amplifier. The pin assignments for these jacks
are shown below.
1: ground
(earth)
3: cold
Unbalanced connection
Use an RCA stereo cable to connect the amplifier to the PHONO OUT jacks.
This unit
(commercially available)
Pre-main amp or
phono equalizer, etc.
Note
The GND terminal is not a safety grounding (earthing) system.
18
2: hot
BALANCED OUT PHONO OUT
R
R GND
RCA stereo cable
PHONO
PHONO inputs
(Unbalanced)
• When connecting, be sure to match the pins and insert
the connector of the "female" XLR balanced cable.
When disconnecting, pull out the "female" XLR
balanced cable while pressing down the latch lock on
the plug.
Latch lock
"Female" XLR connector
BALANCED OUT
Power cord
GND
"Male" XLR connector
STROBE AC IN
Connect to
AC outlet