Haiku Garage Série Manuel D'installation page 6

OCCUPANCY SENSOR TROUBLESHOOTING
Light will not turn ON
If the LED in the sensor lens is not flashing, check all wire connections.
If the LED is flashing:
• Check all wire connections and verify the load wire is tightly secured.
• Check the light level setting. Cover the sensor lens to simulate darkness
in the room. If the light turns on, the light level needs to be adjusted. If
set to the minimum setting, more than 10 fc of ambient light will cause
the light to remain off. See "Configuring the Occupancy Sensor" for
details on setting the light level.
• If the light still does not turn on, contact Customer Service.
Light will not turn OFF
Ensure the time delay is set to the desired delay period and that there is no
movement within the sensor's view during that time period.
To test the sensor for proper operation, set the time delay to minimum and
move out of the sensor's view. The light should turn off after 30 seconds. If
the light does not turn off, contact Customer Service.
Light will not turn ON after installation or power
outage
The occupancy sensor requires time to warm up during initial power-up.
Lights with occupancy sensors may take up to one minute to turn on after
initial installation or after a long power outage.
4
WWW.HAIKUHOME.COM © 2015 HAIKU HOME. ALL RIGHTS RESERVED.
®