Haiku Garage Série Manuel D'installation page 5

CONFIGURING THE OCCUPANCY SENSOR
CAUTION: Do not over-turn the trimpots when adjusting the sensor.
!
Do not touch the square infrared detector under the lens assembly.
Note: The light includes an occupancy sensor only if ordered.
To adjust the settings on fixtures with an occupancy sensor:
1. Carefully unscrew the lens assembly from the bottom of the light.
Do not remove the tightening ring.
2. Set the light level and time delay using the two trimpots.
• Light level. Specify the ambient light level above which the light will
turn off while the space is occupied. When the ambient light level
drops below the set level while the space is occupied, the light will
turn on. The light level can be set from < 10 fc to > 120 fc. The default
setting is 120 fc (maximum). At this setting, the light will stay on at any
ambient light level below 120 fc while the space is occupied.
• Time delay. Specify how long the light will stay on after occupants
leave the space. The time delay can be set from 30 seconds (fully
counterclockwise) to 30 minutes (fully clockwise). The default setting
is 15 minutes.
3. Reattach the lens assembly.
Light
Level
WWW.HAIKUHOME.COM
Time
Delay
© 2015 HAIKU HOME.
®
20 min
15 min
10 min
5 min
30 s
Time Delay Trimpot Positions
ALL RIGHTS RESERVED.
25 min
30 min
3