Kerstar KV20 Mode D'emploi page 5

ENGLISH
GB
UNPACKING YOUR VACUUM CLEANER
Unpack your cleaner and ensure that you have the spares and accessories as listed on the
delivery note.
Note
This range of dry industrial vacuum cleaners has a hose entry which will accept 32, 38 and 51mm
diameter hoses. Hoses and accessories are usually supplied to your order/requirement. Please
check you receive the accessories ordered.
Models on a caddy (KV45, 65 & 110) are packed with the caddy handle removed for transport/packing
purposes. Refi t the handle before use.
OPERATING INSTRUCTIONS
1. Connection to the Electricity Supply
Insert the mains plug into a suitable socket outlet. When you have fi nished cleaning unplug the
appliance. When coiling the mains cable make sure that any twists or knots in the cable come
out at the plug end. DO NOT coil cable from the plug end as all twists and knots remain in the
cable and considerably shorten its life.
2. Cleaner Controls
The following controls are provided:
a) The on/off switch is situated on the top of the motor head. To switch the appliance on fi rmly
press the part of the switch marked "1". To switch off press the part of the switch marked "0".
(Some models are fi tted with one switch per motor)
3. Carrying and Storing
The assembled cleaner should only be moved by the carrying handle on top of the motor head. (Not
applicable to models on a caddy). Do not attempt to lift or drag the machine by the mains lead. The
cleaner must be stored indoors and in a dry environment.
4. Access to the Filtration System
a) To remove the motor head, unclip the clips. Ensure that the clips are hinged clear of the rim of
the motor head. Lift the motor head clear of the cannister.
b) To refi t the motor head align the head so that the cable entry lies directly opposite the hose entry
on the cannister. Locate the clips over the rim of the motor head and fi rmly press down the
clips until they have locked into position.
5