Kerstar KV20 Mode D'emploi page 3

ENGLISH
GB
Safety Instructions – Electrical Safety (UK only)
This vacuum cleaner is a Class 1 earthed appliance and has 10 metres of 3-core fl ex with a
moulded-on non-rewireable 13 amp 3 pin plug (to BS1363A). The fuse fi tted (ASTA Approved) is
rated at 13 amps. Only 13 amp fuses must be used. Note: Fuses do not give personal protection
against electric shock.
Should the moulded-on plug be damaged please follow this procedure:
Switch off supply at socket, remove damaged plug from socket, cut plug off fl ex.
Make sure the damaged plug is disposed of immediately so as there is no chance of the
damaged plug being used.
Fitting a Replacement Plug
Use only a 13 amp (approved) plug. To fi t proceed as follows:
1) Ensure that the lengths of wire to be fi tted inside
the plug have been cut to the correct length and the
ends correctly prepared. When preparing the cable
ends take care not to damage the outer sheath, or the
insulation surrounding the inner conductors.
2) Connect the blue (NEUTRAL) wire to the terminal
in the plug which is marked with the letter "N" or
coloured black.
3) Connect the brown (LIVE) wire to the terminal in
the plug which is marked with the letter "L" or
coloured red.
4) Connect the green/yellow (EARTH) wire to the
terminal in the plug which is marked with the letter
"E" or coloured green.
5) Tighten all screws. Ensure that all conductor strands have entered into the terminal posts and that
the mains lead is securely held in place by the cable clamp.
6) Ensure that the plug is fi tted with a 13 amp ASTA approved BS1362 fuse. Replace the top
cover of the plug and secure.
3