Accessories - WOLFF Profi Traduction Du Mode D'emploi Original

Comes with:
Circle cutter
Acrylic plate
Extensions up to 130 cm radius
Power strips
Pencil
Replacement blades
Carrying case
45
1
#015626Fugenfräse FRÄSMASTER
Kreisschneider Profi,

1.0 Accessories:

Extensions up to 5 m radius . . . . . . . . . . . . . . . . . . . .#015629
Adapter for milling machine . . . . . . . . . . . . . . . . . . . . .#015627
Machine mounting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
with Euro 43 mm receiver . . . . . . . . . . . . . . . . . . . . . .#015630
Adapter for corner and wall radius . . . . . . . . . . . . . . . .#015631
2.0 Fastening the circle cutter onto the flooring
The circle cutter is fastened with 2 extractors onto the flooring.
With coarse floorings like carpet or parquet an acrylic plate is
laid under.
We recommend using the acrylic plate with all types of floorings.
Doing so, the power of the extractors is sufficient for a period of
30 min to 1 hour.
stick 4 power strips onto the acrylic plate and remove the
back of the strips
centre the acrylic plate on the circle centre and press it down
centre the centre pin of the circle cutter to the plate
press circle cutter down and fasten it with the extractor
levers
3.0 Adjusting the radius
The radius of circles up to 45 cm is adjusted with the integrated
scale. The scale always shows the radius, not the diameter.
With larger circles use the extensions and adjust the radius with
a meter rule.
To adjust the radius, loosen the thumb screws at the extensions.
Push in the extensions into the circle cutter more than 50 % of
its length. This improves the stability of the device.
4.0 Scribing or cutting: depth adjustment of the blade
The depth of the blade can be adjusted exactly - depending wether
you want to scribe or cut.
The blade mounting on rollers always keeps the depth constant.
By turnin
g thumb screw (1) you adjust the depth.
5.0 Application
Depending on the type of flooring the circle cutter is used differently.
We recommend the methods listed below:
textile flooring
resilient flooring
blade
parquet + laminate
marking with pencil)
cutting
scribing cutting with a knife with hooked
milling with milling machine (or
8