Soldering Station; Operating Elements And Connections; Safety Notes - Monacor SIC-530ROHS Mode D'emploi

Soldering station

These operating instructions are intended for users
with basic knowledge in soldering technology .
Please read the instructions carefully prior to
operating the unit and keep them for later ref-
erence .
All operating elements and connections de-
scribed can be found on the fold-out page 3 .
1 Operating Elements and
Connections
1 Soldering iron support
2 Slot to slide in the soldering iron support
3 LED temperature display
4 5-pole DIN jack to connect the soldering iron
5 Toggle switch to switch the soldering station
on and off
6 Rotary control to set the soldering temperature
7 Switch DISPLAY to change the temperature
display (3);
Position SET:
Position READ: Display shows the current sol-
8 LED indicator HEATER ON
9 Status indicator of the temperature display
When the switch DISPLAY (7) is in the position
SET, the left field SET will light up: The display
will show the desired soldering tip temper-
ature .
When the switch DISPLAY is in the positon
READ, the right field READ will light up: The
display will show the current soldering tip
temperature .
10 Angled 5-pole DIN plug of the soldering iron
11 Screw sleeve of the soldering iron
12 Soldering tip

2 Safety Notes

This unit corresponds to all relevant directives of
the EU and is therefore marked with
WARNING The unit uses dangerous mains
voltage . Leave servicing to skilled
personnel only . Inexpert handling
may result in electric shock .
6
Display shows the desired
soldering tip temperature set
with the rotary control
dering tip temperature
.
•
The unit is suitable for indoor use only . Protect
it against dripping water and splash water, high
air humidity and heat (admissible ambient tem-
perature range 0 – 40 °C) .
•
Do not place any vessels filled with liquid, e . g .
drink ing glasses, on the unit .
•
Keep the unit away from children!
•
To prevent a fire or any other damage, always
put the hot soldering iron into its holder or on
a fire-proof surface .
•
Only seize the hot soldering iron by its handle .
Never touch the metal parts of the hot soldering
iron – risk of burning! After operation, allow the
soldering iron to cool down in air only, never
use water to quench it .
•
Immediately disconnect the mains plug from
the mains socket if
1 . there is visible damage to the unit or to the
mains cable,
2 . a defect might have occurred after the unit
was dropped or suffered a similar accident,
3 . there are malfunctions .
The unit must in any case be repaired by skilled
personnel .
•
A damaged mains cable must be replaced by
skilled personnel only .
•
Never pull the mains cable to disconnect the
mains plug from the mains socket; always seize
the plug .
•
For cleaning the housing, do not use any ag-
gressive detergents or chemicals . Never im-
merse the station in liquid and make sure that
no liquid will enter the station .
•
No guarantee claims for the unit and no liability
for any resulting personal damage or material
damage will be accepted if the unit is used for
other purposes than originally intended, if it is
not correctly connected or operated, or if it is
not repaired in an expert way .
•
Important for UK Customers!
The wires in this mains lead are coloured in
accord ance with the following code:
blue = neutral; brown = live
As the colours of the wires in the mains lead
of this appliance may not correspond with the
coloured markings identifying the terminals in
your plug, proceed as follows:
1 . The wire which is coloured blue must be con-
nected to the terminal in the plug which is
mark ed with the letter N or coloured black .