Installation And Commissioning - esotec Water Drops Professional Mode D'emploi

6. Installation and commissioning

1. Carefully remove all parts from the packaging. Make sure that you
have definitely removed all parts before you dispose of the packa-
ging materials in an environmentally friendly manner.
2. Now attach the connection hose with the check valve (Fig. 2) to the
'Water Outlet' output of the watering computer. Use an approx. 20
cm long piece of 8 mm hose for this.
3. Now lay out the supply hose (8 mm) as shown in Figure 1. Install
the 5 reducers 8/4/8 mm into this line (as required). Please note
that each reducer can supply max. 10 water droppers with water.
Assembly of the T-distributor 8/4/8
- Unscrew the two screw connections from the
T-piece (Fig. 3/1).
- Insert the hose through the screw socket and
push it firmly onto the cone provided on the
T-piece (Fig. 3/2).
- Push the two screw connections over the hoses
and tighten them.
Note: Please only tighten the screw connections by hand. Do not use
pliers or similar for this.
4. As soon as you have laid out the main supply hose, close it at the
end with the cap supplied (Fig. 4).
5. Now position the water droppers as shown in Figure 1. The water
connection is made via the 4 mm T-piece and the 4 mm outlet
hose. The hose is simply pushed onto the connection on the back
of the dropper. The droppers can be attached to the ground spike.
In order to ensure a good and stable water supply, at least 20 wa-
ter droppers should be connected to the watering computer.
6. Now switch on the watering computer on its underside (ON / OFF).
Then press the 'TEST MODE' button on the touch control panel.
The system now draws in water and, at the same time, ventilates
itself. Once water is coming from all the droppers, please press the
'MODE SELECT' button until the desired watering time appears.
The system will now water automatically at sunrise and sunset.
Note: Please also note the operating instructions for the watering
computer!
3
2
4
Hose cap
5
Hose
4 mm
Holder
2
1
11