17
19
21
Click!
23
3
18
20
22
24
APRON
To attach the apron onto the stroller:
- Slip the apron up over the bottom of the seat unit and attach the Velcro (18) around
the bumper bar.
- Fold the top of the apron back over the bumper bar (19).
THE NET BASKET
- Easy storage thanks to the press studs on either side of the basket.
WARNING
: The maximum load in the basket not to exceed 2kgs.
WARNING
: Only use compartments provided for storage and do not exceed
recommended weight.
WARNING
: Empty the basket completely BEFORE folding the stroller.
PROTECTION AGAINST COLD, WIND and RAIN
- Zip the raincover onto the hood, pull it down to cover stroller seat unit and attach the
two elastic pieces together (20).
EASY TO ATTACH BRACKETS
The Easy to Attach brackets allow you to install the RED CASTLE SPORT / RECARO car
seat (optional) on the stroller:
- Fit the Easy to Attach brackets in place below the handle of the car seat (21).
- To remove them: press in the button located on the side of the car seat and pull on
the bracket then do the same on the other side (22).
N.B: When the Easy to Attach brackets are in place, you do not need to remove them
to use the car seat in the car.
RED CASTLE SPORT / RECARO Car seat (optional):
PREPARING THE STROLLER:
- Remove the hood and bumper bar set (see chapter hood/bumper bar set).
- Undo the seat unit from your stroller
How to undo the seat unit:
• Open the zip behind the seat unit and free the fabric from the chassis (23).
• Undo the strap and the 4 press studs located below the seat unit (24).
• Put the seat unit in the horizontal position (see chapter Adjustments seat back).
• Pull the seat unit forwards to remove it from the chassis (25). Press simultaneously
on the 2 sprung buttons and push in the "U" shaped tube as far as it will go (26).
This reduces the length of your stroller.
HOW TO INSTALL THE CAR SEAT
- Position the car seat as shown then press on it until "click" heard (27).
- To remove it, press on the raised buttons located on the car seat and lift up the car (28).
WARNING: Always check that the Easy to Attach brackets are fitted properly before
installing the car seat.
GB
16