Freudenberg LeaCo Instructions D'utilisation page 13

Start-up
Extending the range – using a repeater
To extend the range of the sensor, use a repeater.
Ideally, position it half way between the display mod-
ule and the sensor.
It is also possible to amplify the signals of several
sensors using one repeater. For very long distances
or very adverse conditions, several repeaters can be
installed to ensure optimal transmission.
The repeater is already fully functional upon delivery
and does not need to be activated. Just plug it into a
power outlet using the USB port.
Positioning the display module vertically and align-
ing it in the direction of reception can improve the
connection range.
Extending the range using a repeater
Sensors
Repeater
24
Checking the connection
The radio connection between the sensor and the
display module is checked at regular intervals. If the
connection is interrupted, this will be indicated on the
display module.
If you still wish to check the connection manually,
perform a connection check. To do this, press the
activation button again using a paper clip.
connection to the display module. If the indicator
light only flashes once, there is no connection
to the display module. In this case, the distance
between the sensor and the display module must
be shortened or a repeater must be connected (see
section «Extending the range – using a repeater»).
Sensor
Display
Module
If the indicator light flashes twice, there is a
Extending the range using several repeaters
Repeater
Repeater
EN
Display
Module
25