GEA PCR06BATSS Manuel D'utilisation Et D'installation page 15

Problem
Moisture forms on
outside of appliance
Frost or moisture
collects inside
Interior light does
not operate
Hot air from bottom
of appliance
off but temperatures
are OK
Possible Causes
Not unusual during periods
of high humidity.
Door left open.
Too frequent or too long
door openings.
In humid weather, air carries
moisture into appliance when
door is opened.
Temperature control set at
coldest setting.
Appliance is unplugged.
The circuit breaker is tripped/
the fuse is blown.
Light bulb needs replacing.
GFI outlet is tripped.
Normal air flow cooling motor.
Adaptive defrost keeps
compressor running during
door openings.
What To Do
• If bothersome, wipe surface dry; otherwise, moisture
will evaporate in time.
• Always make sure that the door is closed after opening.
• Check to see if a bottle is holding door open.
• Appliance will dissipate moisture in time.
If bothersome, wipe surface dry.
• Appliance will dissipate moisture in time.
If bothersome, wipe surface dry.
• See Temperature Control section.
• Push the plug completely into the outlet.
• Replace fuse or reset the breaker.
• See Care and Cleaning section.
• Reset outlet.
• GFI outlet is not recommended.
• In the refrigeration process, it is normal for heat to be
expelled in the area under the appliance. Some floor
coverings are sensitive and will discolor at these safe
and normal temperatures.
• This is normal. The appliance will cycle off after the
door remains closed for two hours.
• Normal operation in extreme temperatures.
GEAppliances.com
15